I’m not ashamed to say I use reusable grocery bags every time I go to the grocery store (unless I forget to bring them with me). Yesterday I went to an event where they handed out fabric bags to throw your goodies in, and my first thought was “Yay another grocery bag!” My family also holds onto gift bags and reuses the same ones over and over and over again. So I thought to myself, why not sew a fabric gift bag?
A little drawstring Christmas pouch is great for small gifts, candy, ornaments, etc. It’s reusable, and the drawstring opening builds suspense by completely concealing what’s inside. And if your Christmas party is lacking anything, it’s suspense.
What you’ll need:
- A Christmas fabric
- Matching thread
- A safety pin
First I take a cut of fabric that’s about twice as long as it is wide.
I press them in half where the bottom of the bag will be, and the two free ends that meet at the top will form the opening.
My ribbon is 3/8″ wide, so I’m making the drawstring casing 1/2″ wide to allow adequate room. to make sure no frayed edges are exposed, Fold over about 1/8″ on the edge of the fabric and stitch it in place. Only one side is pictured above, but I do this on both sides of the opening.
Next I fold down 1/2″ and press to form the casing.
I stitch down the casing with a zigzag stitch to keep the edge from fraying as much. I could theoretically overlock and then straight stitch it down, but the zigzag stitch just looks more fun. And in the words of Sheldon Cooper, “What’s life without whimsy?”
Next I pin the right sides together to form the sides of the bag, and these I stitch with an overlock stitch and no seam allowance so that the stitch will line up perfectly when the edge of the casing. Make sure to leave the opening of the casing free so you can insert the ribbon!
To make the bag stand up on its own, you’ll want to sew the corners of the inside into two triangles that will lay flat against the bottom. I don’t know if there’s a science to determining how wide you want your triangles, but I make mine half the width of my pouch. My pouch is 6 inches wide, so you can see in the picture that I’m making my triangles 3 inches wide, with the side seam right in the middle. I draw a line where my gauge is measuring 3 inches and stitch right along that line, then draw a similar line on the other side and repeat.
A view from the top after I stitched my corners.
Next it’s time to insert the ribbon and make it a drawstring pouch!
I used leftover pieces of ribbon from another project that weren’t quite long enough, but you’ll want yours to be twice the width of your bag plus a couple of inches. My pouches were 6 inches wide, so I should have used 14 inch ribbons, but alas.
Affix a safety pin to the end of one of your ribbons, and insert it into one of the casings. When you reach the next opening, keep pushing the ribbon through the other side of the casing until the ribbon has come full circle.
Now you’re halfway done!
Finally, attach the safety pin to one end of your second piece of ribbon, and insert it into the other side of the opening, where your first ribbon simply continued through without stopping. You’ll again want to move the ribbon all the way through so that both ends of the same ribbon are on the same side of the opening.
And voila! You have a drawstring little pouch for Christmas. I think these would be great if you’re having a party and want to give out little goody bags, and you can make it taller or wider as you so desire!